When troubleshooting USBDM (Universal Serial Bus Debug Module) connection errors, the most common error message is “Target Connection Failure: USBDM can’t enable BDM mode on the target”. This usually indicates an issue with target security, physical wiring, or software environment conflicts.
The primary, proven quick fixes to resolve these USBDM communication failures can be broken down by their direct causes. 1. Fix Target Device Security Locks
If your Freescale/NXP microcontroller is secured, the USBDM will refuse a connection.
Use Stand-Alone Programmers: Close CodeWarrior and open the stand-alone utility matching your architecture (e.g., HCS12_FlashProgrammer.exe or CFV1_FlashProgrammer.exe). Load your project’s .s19 file and click the Unsecure button to force a mass erase and unlock the chip.
Manual BKGD Short: For stubborn HCS08 or HCS12 chips, power off the target board, manually short the BKGD signal pin to GND, power the board back on, remove the short, and quickly click “Program”. This prevents the chip from executing corrupt or locking firmware on boot. 2. Configure Power Control & Reset Settings
Improper voltage alignment or lack of a power cycle will disrupt the BDM connection handshake. Troubleshooting USBDM
Leave a Reply